The ST660 delivers enhanced screen compatibility, accommodating large flat panel screens including those with VESA® 800 x 400 mm hole pattern. Its open wall plate architecture delivers placement flexibility and increased electrical and cable management access. Unique pre-tensioned universal tilt screen adapters provide one-touch tilt viewing angle adjustment completing the perfect flat panel installation.
Customer Reviews:
Avg. Customer Rating: 4.5 / 5.0
Sturdy, but tilt adjustments are a chore:
I bought this wall mount over others because it can be tilted upwards 5 degrees, allowing easier access to cables on the back of the TV. The hand-tightened screws which allow setting the tilt angle are not adequate for my 50" plasma -- the TV tilt angle slowly drops down to face the floor (greater than 20 degrees tilt). Thus, you must use a special hex tool supplied with the mount to set the tilt angle in fixed 5 degree increments. However, inserting the required screws in one of the 5 degree increments... more info
This thing works great!!!!:
This bracket holds up my 52 inch TV with no problem. It is also easy to adjust. I would recommend it.
Worked Great.:
Screw buying these wall mounts for 400% mark up at Best Buy... this thing did the trick for 25% of the price. It was easy to use and the instructions were actually in english. It holds up my 52" Samsung 1080P perfectly.
Good frame, beware of instructions:
Good frame and hardware. Fit my Panasonic 46" plasma perfectly. However, the instructions almost led to an installation error. The instructions stated that the top mounting bolts of the frame should be measured at 6.2" above the center of the screen. Luckily, I decided to mount the brackets on the TV, then put the frame on while the TV was on the ground and measure to the top of the TV from the top of the frame. There was 2" more to the top of the TV then when following the 6.2" instructions. If I would... more info
